caribbeanlobi.blogg.se - Install aquaterm

#INSTALL AQUATERM INSTALL#
#INSTALL AQUATERM DOWNLOAD#

Then I ran the command line again in terminal “sudo port install gnuplot” and it appeared to be installing the everything and took a while doing so. Then I had the issue huatojulio had and fixed it by downloading the file in xCode as instructed.

#INSTALL AQUATERM DOWNLOAD#

Hi there, I am extremely new to LaTex and gnuplot and i’m trying to download gnuplot to try it out.įirstly I downloaded marports and then ran the command line “sudo port install gnuplot” as instructed. I’m a bit lost here, so I hope that you can help me 🙂 Thank you for posting the tutorial in the first place! If I do man readline, I get a working man page – does this mean that it is properly installed? When I try to read the Makefile in /shlib/, it says -dynamic rather than -dynamiclib, even though I checked that it was saved properly before attempting the commands. Which did a whole bunch of stuff which I won’t paste here, but I don’t think it was a success – I’m not sure, though. Install: /usr/local/include/readline/rltypedefs.h: Permission denied Install: /usr/local/include/readline/rlconf.h: Permission denied Install: /usr/local/include/readline/rlstdc.h: Permission denied Install: /usr/local/include/readline/tilde.h: Permission denied Install: /usr/local/include/readline/history.h: Permission denied Install: /usr/local/include/readline/keymaps.h: Permission denied Install: /usr/local/include/readline/chardefs.h: Permission denied Install: /usr/local/include/readline/readline.h: Permission denied usr/local/share/info /usr/local/share/man/man3įor f in readline.h chardefs.h keymaps.h history.h tilde.h rlstdc.h rlconf.h rltypedefs.h do \ usr/local/include/readline /usr/local/lib \ support/mkinstalldirs /usr/local/include \ Srens-MacBook-Pro:readline-6.2 Soeren$ make install

I assume that by “the directory”, you mean /readline-6.2. Hm, I’ve attempted to do this, but it doesn’t quite work. Go to the directory and run the following command. You may find an error saying: use dynamiclib instead of dynamicĤ. Search -dynamic and change it to -dynamiclib. go to shlib subfolder, and open Makefile. Unzip the downloaded file, and copy the file to the location you want to install (i.e. Download the latest read line lib source from here.Ģ. I am a command line newb and completely new to the configure and make commands as well as Makefile.ġ. I’ve been trying to follow your instructions here, but it is not going well for me. Special thanks to Bhou for your helpful post regarding gnuplot installation. Now you can type, gnuplot and start using it 🙂

And, run the following for the installation.

Unzip it, and go to that working directory.

Download the latest gnuplot source packages from here.

Go to the directory and run the following command.

You may find an error saying: use dynamiclib instead of dynamic Search -dynamic and change it to -dynamiclib.

go to shlib subfolder, and open Makefile.

Unzip the downloaded file, and copy the file to the location you want to install (i.e.

Download the latest read line lib source from here.

Perform the following to install read line lib: If you don’t want to install macports, then you can proceed with the following steps.īefore you download and install the gnuplot, you need to download Read Line lib for gnuplot. Just Install macports and run “sudo port install gnuplot”, and this will install gnuplot along with all the dependencies. The easiest way of installing gnuplot is using macports.